Oregon Scientific Weather Station WMR86A & Arduino Data Logger

Oregon Scientific Backyard Pro Weather Station WMR86A


Rob Lakes (robwlakes) ArduinoWeatherOS


Notes so far…
Weather vane component needs to extend north from mounting pole. Don’t know of a way to calibrate it if mounting in this fashion is not possible.
Press Reset button in batter compartment of Display component once all sensor components are installed.
Wait about 2 minutes and time will sync up via radio signal.
There are no on/off switches. Once batteries are installed, they are active.
I was not able to simulate a wind speed. The anemometer may have to run consistently to register properly.

Published by

Leave a Reply

Your email address will not be published. Required fields are marked *

* Copy This Password *

* Type Or Paste Password Here *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>